How to Apply your Lashes:
1. Apply Bond underneath your natural lashes, less is more. Wait 30-60 allowing the bond to get tacky.
2. Place lashes underneath your natural lashes, 1-2mm away from the waterline.
3. Gently bind your lashes together with applicator to secure them.
4. Apply sealant mainly on the lash roots.
5. Do not wet your lashes for 24hrs.
How to Remove your Lashes
- Using our Minute Goo lash oil remover, close your eyes and smear the remover on top and underneath your lashes. Leave it on for 30-60 seconds
- Once the lashes feel loose, grab a cotton tip, and gently swipe them down. If required apply another layer off remover onto the lashes to remove stubborn or excess bond.
- You can either wash your lashes or use an eye make-up remover to fully clean your lashes from the oil remover.
How to Clean and re-use your Lashes
What you need:
Small container, iso-propyl alcohol, spoolie, paper towel and a Q-tip
- Soak your lash clusters in a small container of alcohol for 5-10 min
- Lay the lashes on the paper towel and use the Q-tip to clean off the excess bond.
- Brush off the lash clusters using the spoolie to retain the curl of the lashes. Once its fully dry store them back in its original packaging.
Now you can re-use your lashes up to 2-3 times
